Combing a Prismatic Joint component with an Elasto Gap component does not always provide correct results. Incorrectly combined (red mass below), a force is generated although the distance between the flanges is greater than the relaxed spring length. A force is exerted (instead of no force is exerted as stated here) on the mass which leads to a smaler deflection (expected are 9.81 m).

This happened to me although I connected flange_a to flange_a and flange_b to flange_b in configruation A bellow. Configuration B works with inverted flanges and configuration C works with inverted unit vector of the prismatic joint. By reversing the direction of gravity, configuration A becomes a valid configuration and configurations B and C become invalid configurations.

It seems that in invalid configruations the value of the  flange distance s_rel can have a large magnitude but is negative in sign which generates significant forces although there is no contact of flanges.

So far for the observations.


Would a change of the contact condition

prevent invalid configurations or do we have to live with it for principal reasons that I am over looking?

If so, I don't see a foolproof method to avoid invalid configurations. Instead, I can only suggest measuring the flange distance of the Elasto Gap component as in the attached. If negative values of large amplitude occur, the configuration is invalid.

Assuming that a beginner would connect intuetively flange_a to flange_a and flange_b to flange_b, there is a chance of 50% that the configuration is invalid (A instead of C). This is too much to be acceptable, especially since verifying results in complex assemblies is often not possible.

It is worth noting that the contact condition comes from the underlying Modelica component and not from MapleSoft.


Please Wait...